Surf rod butt diameter,

[Sudsrat]

Looking for the diameter of the butt caps on the
Ocean Master,Breakaways,Ticas etc.Need accurate(vernier/caliper)measurements on these and other rods with overly large butts.
Thanks

[team last cast too]

SUDSRAT,

Contact me at www.customrodbuilders.com (http://www.customrodbuilders.com) with the specific rod in question and I can get you the info you need.

Tight lines,
Kevin Team Last Cast

[Last Cast]

Sudsrat,

just shot you an email. I would say go with 1 3/4". Thats what our current supplier uses. Some of the cheaper rods have bigger butt caps.

Good Luck! Las Cast (http://www.customrodbuilders.com)

[Sudsrat]

Thanks Tom,
I sent you one back.Just so I know we are on the same page ,I'm inquiring about the butt 'cap'
dia.Not the dia. of the rod blank butt.

[Eric G]

Welcome to the BassBarn advertising community www.customrodbuilders/Last (http://www.customrodbuilders/Last) Cast!!!