I've got 65K invested in this boat...but I hate to see her sit.
33 Concorde....amazing offshore hull....HEAVY boat.
I've been in some nasty stuff in this boat and she takes it like no other boat in the size class. Like riding in a 72 Caddilac. 33 foot Concorde Hull....if it were measured by todays standards, she'd be 38ft.....pulpit to trim tabs...so it's 33 foot of fiberglass in the water.
33' hull....13'6" beam.
Huge cockpit....roughly 12' X 12'
Hull was Awlgripped in 2006....fighting lady yellow w/ forrest green bootstripe.
Interior was torn out and all is new in salon. tons of pics...all solid mahogany custom interior with new upholstery.
New Stainless fridge, sink, mircowave, carpet.
16K BTU Cruisair reverse cycle heat/air
New 4K Kohler Diesel Genset...might have 20 hours on it.
Recent repower (roughly 600 hours as a conservative extimate)8.2 liter turbo intercooled 300 HP Detroit diesels....cruise the boat at an honest 24-26 knots. Top out at 29 knots. Cruise to the Baltimore from Cape May, troll all day and back on 150 gallons of fuel.
Remaining work to complete - Needs deck repaired... topsides painted and halftower reinstalled or replaced, electronics re-installed. She's not in turn key condition right now...but I can walk you through the boat...show you everything I know about her...what has been done and what needs to be done.
Hardtop was removed to transport boat to my home...as was the half tower. I do have it all, along with the overhead electronics box.....but was planning on going new. It will go with the boat if you want it.
Details not to miss
I've got a spare pair of 8.2TI 300HP marine diesel parts engines..complete from oil pan to turbos that go with the boat. You could literally run the boat and have parts for ten years with the parts engines that go with it.
Also have a spare 4KW Kohler minus the generator end for parts...but the one installed is spankin new. (engine on genset is 2 cylinder 2GM Yanmar). The end went on it and rather than replacing the end, I found a new, old stock same Genset...so just replaced it....engine ran perfectly.
I've lots of pictures of the boat...just ask. Located in Franklinville NJ....08322.
If you're looking to get into charter fishing and don;t want to invest a heap of money...this is your machine. It was actually a 6 pack charter boat out of Ocean City MD for years...again...an unbelievable hull.
$29,900
33 Concorde....amazing offshore hull....HEAVY boat.
I've been in some nasty stuff in this boat and she takes it like no other boat in the size class. Like riding in a 72 Caddilac. 33 foot Concorde Hull....if it were measured by todays standards, she'd be 38ft.....pulpit to trim tabs...so it's 33 foot of fiberglass in the water.
33' hull....13'6" beam.
Huge cockpit....roughly 12' X 12'
Hull was Awlgripped in 2006....fighting lady yellow w/ forrest green bootstripe.
Interior was torn out and all is new in salon. tons of pics...all solid mahogany custom interior with new upholstery.
New Stainless fridge, sink, mircowave, carpet.
16K BTU Cruisair reverse cycle heat/air
New 4K Kohler Diesel Genset...might have 20 hours on it.
Recent repower (roughly 600 hours as a conservative extimate)8.2 liter turbo intercooled 300 HP Detroit diesels....cruise the boat at an honest 24-26 knots. Top out at 29 knots. Cruise to the Baltimore from Cape May, troll all day and back on 150 gallons of fuel.
Remaining work to complete - Needs deck repaired... topsides painted and halftower reinstalled or replaced, electronics re-installed. She's not in turn key condition right now...but I can walk you through the boat...show you everything I know about her...what has been done and what needs to be done.
Hardtop was removed to transport boat to my home...as was the half tower. I do have it all, along with the overhead electronics box.....but was planning on going new. It will go with the boat if you want it.
Details not to miss
I've got a spare pair of 8.2TI 300HP marine diesel parts engines..complete from oil pan to turbos that go with the boat. You could literally run the boat and have parts for ten years with the parts engines that go with it.
Also have a spare 4KW Kohler minus the generator end for parts...but the one installed is spankin new. (engine on genset is 2 cylinder 2GM Yanmar). The end went on it and rather than replacing the end, I found a new, old stock same Genset...so just replaced it....engine ran perfectly.
I've lots of pictures of the boat...just ask. Located in Franklinville NJ....08322.
If you're looking to get into charter fishing and don;t want to invest a heap of money...this is your machine. It was actually a 6 pack charter boat out of Ocean City MD for years...again...an unbelievable hull.
$29,900
