BASS BARN banner
1 - 9 of 9 Posts

·
Registered
Joined
·
3,578 Posts
Discussion Starter · #1 ·
I need a mounting bracket and 2 knobs for a furuno 1650. Also need a navionics or c-map chip to fit the unit for the NJ and offshore waters. Thanks
 

·
Registered
Joined
·
13,697 Posts

·
Registered
Joined
·
3,072 Posts
Harv, If you call Martek in Marmora, they have a lot of brackets and parts in the basement. Whenever they do a flush mount, they have a bracket left. They may have a dead unit with the knobs, too. Also, I'm pretty sure those units are made specifically for c-map OR navionics. If the model number includes NT it takes C-map. Otherwise it's Navionics. As far as I know they are not interchangable. Good luck.
 

·
Registered
Joined
·
3,578 Posts
Discussion Starter · #6 ·
Tight Lipped.......Thanks for the link. I have found out that my unit takes the navionics chips, not the c map as I had originally thought.
Spooled.......Thanks, I will let you know when it arrives.
Aimless.......Thanks, I will check with Martek. Thanks.
 

·
Registered
Joined
·
267 Posts
Capt. Harv,

I have a mounting bracket and knobs for a 1650 - let me know if you still need them. Just pay for the postage and they are yours.
 

·
Registered
Joined
·
3,578 Posts
Discussion Starter · #8 ·
Brian...That would be great. Let me know your address and the shipping cost and I will gladly send you a check. Thanks
 

·
Registered
Joined
·
480 Posts
This is how the barn should work! Way to go Brian.
 
1 - 9 of 9 Posts
Top