BASS BARN banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,938 Posts
Discussion Starter · #1 ·
Used flex-cote on a little repair to a wrap on one of my plugging rods. Don't know if epoxy was too old or I made a bad mix. At any rate it's still tacky after four days. Is there any way to flash this up or whats the best way to remove? Thanks
 

·
Registered
Joined
·
25 Posts
You can apply another coat but use make sure the mix is 50/50 or if you think it is caused be some bad FlexCote get some new finish and apply.
 
1 - 2 of 2 Posts
Top