[Irish Wake]

Im looking to Install Lenco Trim Tabs on a Dusky 256fac with twin 150’s,could use some Info,I have 12inch from the Motor Bracket to the out side edge of the Hull,so the widest trim tab that will fit would be 12inch,Lenco has tabs 12x12 and 12x18,with 12 being the width of the tabs,what size would work best on A 28FT CC,I would Appreciate any Info.

 

[FIN-ALLYCC25]

Im looking to Install Lenco Trim Tabs on a Dusky 256fac with twin 150’s,could use some Info,I have 12inch from the Motor Bracket to the out side edge of the Hull,so the widest trim tab that will fit would be 12inch,Lenco has tabs 12x12 and 12x18,with 12 being the width of the tabs,what size would work best on A 28FT CC,I would Appreciate any Info.

You might be good with the 12x12 Lenco tabs. The 12x18 (18 being the length) might give you too much tab(I can check with a few guys I work with and give you a better answer). It is usually more width the better, but I could be wrong.

By the way, your top looks great, Good Luck with 2010.

 

[fran]

Im looking to Install Lenco Trim Tabs on a Dusky 256fac with twin 150’s,could use some Info,I have 12inch from the Motor Bracket to the out side edge of the Hull,so the widest trim tab that will fit would be 12inch,Lenco has tabs 12x12 and 12x18,with 12 being the width of the tabs,what size would work best on A 28FT CC,I would Appreciate any Info.

On their site, they recommend a 12 X 18 for your size boat. They have 2 one of which is an edge install.

Write to them just in case you have a warranty issue later on.

 

[Captainbob]

12 x 12

If you only have 12" between the bracket and the outside edge, I think that the 12 x 12 is your only choice. A 12 x 18 needs 18" of transom for attachment and if I understand your measurement, that's not going to work.

 

[KING MARINE OUTBOARD]

Send me an email with a picture of the back of your boat along with exact measurements. [email protected] Dean

 

[Bob ECT]

Give Dusky a call they'll tell you what they use. Great people to deal with

 

[captainbadfinger]

If you only have 12" between the bracket and the outside edge, I think that the 12 x 12 is your only choice. A 12 x 18 needs 18" of transom for attachment and if I understand your measurement, that's not going to work.

They are 12in wide and 18in long
We have them on the Cape Horn

Go with the longer ones
I wish ours were a little bigger!!

 

[take one]

hey murph ....go chase down your wallet , i saw it running down the road with a smoke trail behind it

 

[Dunk]

Murph,

You want as big a tab as you can get on there for that boat..

 

[Irish Wake]

Guys, I Appreciate all the Info,Dusky is a Sweet Ride handle rough water great,But anything over 1200rpm to you get on Plane the Bow come up so high you can’t see nothing,even on your tippey toes,Once on Plane no Problem,
Take one,,,Yes I here that, I hope I have GAS money left,and a Wife when I’m done,
But she will be right when Im done for this up coming Season.

 

[ccmarinetowers]

Murph,

You want as big a tab as you can get on there for that boat..

Murph bigger is better don't push them down all the way if you don't
need them but if you do need it you have it :thumbsup:

DUNK did you do chucks boat today at breezy lee Rampage (BLUE CHIP)

 

[Bob ECT]

Guys, I Appreciate all the Info,Dusky is a Sweet Ride handle rough water great,But anything over 1200rpm to you get on Plane the Bow come up so high you can’t see nothing,even on your tippey toes,Once on Plane no Problem,
Take one,,,Yes I here that, I hope I have GAS money left,and a Wife when I’m done,
But she will be right when Im done for this up coming Season.

My 23 was the same way without tabs. Tabs made a huge difference. Call Dusky and see what they put on them.