BASS BARN banner

1 - 2 of 2 Posts

·
Registered
Joined
·
257 Posts
Discussion Starter · #1 ·
My 1994 Evinrude 15hp kicker is ready for a new water pump. I've done this before, so I'm ok there. But, the lube was milky, so it probably needs seals. I need to check the filller washers and have it pressure/vacum tested. My question is the procedure for replacing the drive shaft and prop shaft seals.

I read the prior posts on this subject and the OMC shop manual. The manual tells about tearing apart the entire unit---not just the seals.
Can someone walk me thru removing and replacing them----does the driveshaft have to come out----do I need OMC pullers ?
 

·
Registered
Joined
·
5,270 Posts
You should replace all of the seals, not just the leaking one.
 
1 - 2 of 2 Posts
Top