Raymarine E-120

Stinker · Jun 12, 2006

I installed all new Raymarine Electronics this Spring & and am happy with the performance. My only issue is that I can't seem to get the E-120 Display to show the Water Temp& Boat Speed like it should. The new transom mount transducer is properly installed, has the appropriate sensors, & should be providing the data. I checked most of the manuals & can't seem to trouble shoot the issue. I could care less about the speed sensor, but would like the Temperature to function. Any info would be appreciated. Thanks-

amber lee · Jun 12, 2006

We just installed an E120 this season, but we have the thru hole mount and haven't had any problems. i love the unit, try checking with Capt.Steve from Free Spirit he should be able to help you out.

BM3BANDIT · Jun 12, 2006

YOU WILL ONLY GET IT IF YOU HAVE THE DUCER AND THE DMS BOX. THIS IS HOW TO GET IT UP.

GO MENU, THEN DATABAR SETUP, GO TO CONFIGURE, THEN ADD DATA(ITS A SOFT KEY ON THE BOTTOM), GO TO ENVIRONMET, AND THEN PRESS OK ON SEA TEMP.

Stinker · Jun 13, 2006

Thanks Bandit. (I do have the correct ducer & the DSM300 unit installed correctly). I figured I'd have to sort through a few Menus to configure. I will try it out & Thanks again-

CHUM LEE · Jun 13, 2006

I HAD THE SAME PROBLEM WITH MINE, BANDIT SOUNDS CORRECT IF NOT JUST CALL THEIR 1-800# AND THEY'LL WALK YOU THROUGH IT IN ABOUT 2 MINUTES

Off-line · Jun 13, 2006

Had the C and now the E. Love em' Bandit is right on...it's all in the databar setup.

Good luck,

Jamie

Raymarine E-120

Our Vendors

Top Contributors this Month

Recommended Communities