BASS BARN banner
1 - 4 of 4 Posts

·
Registered
Joined
·
205 Posts
Discussion Starter · #1 ·
Just bought 14ft alum boat for fresh water fishing and rowing. It has about a 2inch crack below the waterline in a flat area. Would like to get some ideas for patch/repair. I think the area is too thin for welding. If I don,t do it myself, is there anyone near that would? Galloway twp area? Also would like to buy a set of used oars approx 6 ft long at a reasonable price. Any comeback??
 

·
Registered
Joined
·
275 Posts
If the boat is in good shape, you see check for a local welder for a price. It shouldn't cost that much and would be permenent!
 

·
Registered
Joined
·
1,931 Posts
check with a local welder. Weld the crack and weld a cover plate over that. sholdn't be too expensive.
 
1 - 4 of 4 Posts
Top